HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 833
sfpShow, Gigabit Interface Converter spec by Sun Microsystems, et al. Use
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 833 highlights
sfpShow 2 sfpShow Displays Small Form-factor Pluggable SFP information. Synopsis sfpshow sfpshow [slotnumber/]geportnumber [ -f] sfpshow -all Description Use this command to display information about Serial Identification SFPs (also known as module definition "4" SFPs). These SFPs provide extended information that describes the SFP's capabilities, interfaces, manufacturer, and other information. Use this command without operands to display a summary of all SFPs in the switch. The summary displays the SFP type (refer to switchShow for an explanation of the two-letter codes) and, for serial ID SFP, the vendor name and SFP serial number. Use this command with a slotnumber and/or portnumber to display detailed information about the serial ID SFP in the specified port. In this mode, this command displays values described in the "Gigabit Interface Converter" spec by Sun Microsystems, et al. Use the -f option to refresh the SFP information. This option is valid only when a spfShow is issued for a specific port. Use the -all operand to display detailed information for all available SFPs. For Finisar "smart" SFPs, this command displays additional fields, including module temperature, voltage, received optical power, transmitted optical power (long wave only), laser diode drive current, optional status/control register, alarm and warning flags, as well as high and low thresholds programmed on the sfps. Notes The sfpShow command does not reflect changes in the sfpShow output if any SFPs are replaced or removed while a port or a switch is disabled. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: slotnumber For bladed systems only, specifies the slot number of the port to display, followed by a slash (/) portnumber Specifies the number of the port for which to display the SFP information, relative to its slot for bladed systems. Use switchShow for a list of valid ports. This operand is optional; if omitted, this command displays a summary of all SFPs on the switch. -f Refreshes the SFP information. This option is valid only when sfpShow is issued for a specific port. -all Displays detailed data for all available SFPs on the switch. This operand is not compatible with slotnumber/portnumber operands. Examples To display SFP summary information: switch:admin> sfpshow Port 0: -Port 1: -- Fabric OS Command Reference 803 53-1001337-01