HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 848

2 SnmpConfig Access Control Configuration Parameters The ACL check is as follows: there are six ACLs to restrict SNMP get, set, and trap operations to hosts under an host-subnet-area. The host-subnet-area is defined by comparing nonzero IP octets. For example, an ACL of 192.168.64.0 enables access by any hosts that start with the specified octets. The connecting host is enabled to set each host-subnet-area to be read-write or read-only. The closest match out of six entries is given access. The ACL check is turned off when all six entries contain 0.0.0.0. The default values of all six entries are 0.0.0.0. For IPv6 subnets, the format is specified by an IPv6 address followed by the number of fixed bits in the address. MIB Capability Configuration Parameters The mibCapability option turns certain MIBS and TRAPS on or off. If SNMP MIB is disabled, then corresponding traps also are disabled. If any trap group is disabled, the corresponding individual traps also are disabled. FA-MIB Specifying yes means you can access FA-MIB variables with an SNMP manager. The default value is yes. FICON-MIB Specifying yes means you can access FICON-MIB variables with an SNMP manager. The default value is yes. HA-MIB Specifying yes means you can access Entity-MIB and HA-MIB variables with an SNMP manager. The default value is yes. FCIP-MIB Specifying yes means you can access FCIP-MIB variables with an SNMP manager. The default value is yes. SCSI-MIB Specifying yes means you can access FCIP-MIB variables with an SNMP manager. The default value is yes. SW-TRAP Specifying yes means the SNMP management application can receive SW-TRAPS from the switch. The default value is yes. You may also turn individual SW Traps on or off. The individual SW traps are swFCPortScn, swEventTrap, swFabricWatchTrap and swTrackChangesTrap. FA-TRAP Specifying yes means the SNMP management application can receive FA-TRAPS from the switch. The default value is yes. You may also turn individual FA Traps on or off. The individual FA Traps are connUnitStatusChange, connUnitEventTrap, connUnitSensorStatusChange and connUnitPortStatusChange. SW-EXTTRAP Specifying yes means you can receive SSN in the SW traps. The default value is no. FICON-TRAP Specifying yes means the SNMP management application can receive FICON traps from the switch. The default value is yes. You may also turn individual FICON Traps on or off. The individual FICON Traps are linkRNIDDeviceRegistration, linkRNIDDeviceDeRegistration, linkLIRRListenerAdded, linkLIRRListenerRemoved and linkRLIRFailureIncident. HA-TRAP Specifying yes means the SNMP management application can receive HA traps from the switch. The default value is "yes". You may also turn individual HA Traps on or off. The individual HA Traps are fruStatusChanged, cpStatusChanged, and fruHistoryTrap. 818 Fabric OS Command Reference 53-1001337-01