HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 608

2 portCfg Note On the Brocade 7800 and FX8-24 platforms IPv6 addresses are not supported in the Fabric OS v6.3.0 release. IPv6 addresses are supported on the Brocade 7500/7500E and FR4-18i. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). ge_port Specifies the number of the GbE port to be displayed. The 1 GbE ports are numbered ge0 - ge9 on the Brocade FX8-24 blade and ge0 - ge5 on the Brocade 7800 switch. The 10 GbE ports on the Brocade FX8-24 blade are numbered xge0 and xge1 (only). The GbE ports on the Brocade 7500/7500E, and FR4-18i are numbered ge0 and ge1. Use the switchShow command for a list of valid ports. ipif Defines the IP interface for both ports of a tunnel. Up to eight IP interfaces per 1GbE port or GbE port are supported. Up to 10 IP interfaces are supported on the 1GbE port. The IP network connection is configured by defining IP interfaces for origin and destination virtual ports, and then defining one or more IP routes to connect them. The syntax for portCfg ipif is as follows: portcfg ipif [slot/][ge]port option arguments Valid options and arguments for ipif are: create src_ipaddr mtu_size Creates IP interfaces. Specify the following: src_ipaddr Specifies source IP address in either IPv6 or IPv4 format: src_IPv6_addr/prefix_len Specifies the source IPv6 address of the virtual port if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. This is used for IPv6 addresses instead of a netmask. The prefix_len operator is required. src_IPv4_addr netmask Specifies the source IPv4 address of the virtual port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well (in a.b.c.d. format.) mtu_size Specifies the maximum transmission unit size. The permitted range is 1260 Bytes to 1500 Bytes for the Brocade 7800/FX8-24 platforms and 1260 Bytes to 2348 Bytes for the Brocade 7500/7500E/FR4-18i. This operand is required. delete ipaddr Deletes IP interfaces. Specify the IPv6 or IPv4 address of the virtual port. iproute Defines static IP routes on a 1/10 GbE port or on a GbE port. After defining the IP interface of the remote switch, you can define destination routes for an interface. A maximum of 32 user-configurable routes per 1/10 GbE port or GbE port are supported. You cannot use this command to configure routes for inband management; use portCfg inbandmgmt instead. The syntax for portcfg iproute is as follows: 578 Fabric OS Command Reference 53-1001337-01