HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 189

cryptoCfg 2 --remove -initiator Removes an initiator from the specified CTC. This command is valid only on the group leader. The following operands are required when removing an initiator: crypto_target_container_name Specifies the name of the CTC fro which the initiator is to be removed. initiator_PWWN Specifies the initiator port WWN. --add -LUN Adds a LUN to a CTC and optionally sets encryption policies for the LUN. LUN policies may be set at this time or after the LUN is added. The maximum number of LUNs you can add in one commit operation is 25. There is a delay of five 5 seconds for each commit operation. This command is valid only on the group leader. The following operands are supported: crypto_target_container_name Specifies the name of the CTC to which the LUN is added. This operand is required. LUN_Num | LUN_Num_Range Specifies the LUN number or a range of LUN numbers. These operands are mutually exclusive. The LUN number can be either a 16-bit (2 bytes) number in hex notation (for example, 0x07) or a 64-bit (8 bytes) number in WWN format (for example, 00:07:00:00:00:00:00:00). When specifying a range, the LUN Numbers must be 16-bit numbers in hex format. The Range parameter is not supported for 64-bit LUN numbers. The LUN number must be zero when a tape LUN is specified and the tape drive is a single LUN device. initiator_PWWN initiator NWWN Optionally specifies one or more hosts (initiators) that will be permitted to access the LUN. For each initiator added, the port WWN and the node WWN must be specified. You may add more than one initiator. Encryption policy parameters: The following encryption policy configuration parameters can be optionally set for disk and tape devices when adding a LUN to a CTC, or they can be set at a later time with the --modify -LUN command. The tape policies specified at the LUN level take effect if you do not create tape pools or configure policies at the tape pool level. LUN policies are configured per HA or DEK cluster. For multi-path LUNs exposed through multiple target ports and thus configured on multiple CTCs on different EEs in an HA cluster or DEK cluster, the same LUN policies must be configured. Refer to the Fabric OS Encryption Administrator's Guide for more information. The following LUN policy parameters can be optionally set: -lunstate encrypted | cleartext Sets the encryption state of a specified disk LUN. When set to encrypted, metadata on the LUN containing the key ID of the DEK that was used for encrypting the LUN is used to retrieve the DEK from the key vault. If the LUN state is not specified, the default state is cleartext. This operand is not valid for tape LUNs. Fabric OS Command Reference 159 53-1001337-01