HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 659

portCfgShow 2 EX_port. Mirror Port FC Fastwrite Rate Limit Credit Recovery Port Auto Disable F_Port Buffers Displays ON when the port is configured as an EX_Port. Otherwise displays (..) or OFF. This value is set by the portCfgExPort command. Displays ON when Mirror Port is enabled on the port. Displays (..) or OFF when Mirror Port is disabled. This value is set by the portCfg mirrorport command. Displays ON when FC Fastwrite is enabled on the port or (..) or OFF when disabled. Fastwrite is disabled by default. This value is set by the portCfg fastwrite command. Displays ON when ingress rate limit is set on the port or (..) or OFF when the ingress rate limiting feature is disabled. This value is set by the portCfgQos --setratelimit command. The default value is OFF. Displays ON when Credit Recovery is enabled on the port. Displays (..) or OFF when the feature is disabled. This value is set by the portCfgCreditRecovery command. The credit recovery feature is enabled by default, but only ports configured as long distance ports can utilize this feature. Displays On when the Auto Disable feature is enabled on a port. Displays (..) or OFF when the feature is disabled. This feature causes ports to become disabled when they encounter an event that would cause them to reinitialize. This feature is enabled by the portCfgAutoDisable command. The feature is disabled by default. Displays the number of configured F_Port buffers. Displays (..) or OFF if no buffers are configured. The buffer value is set by the portCfgfPortbuffers command. Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. The Fabric OS port configuration commands are not supported on FcoE ports. Use fcoe --cfg to configure FCoE ports. Operands This command supports the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the number of the port to be displayed, relative to its slot for bladed systems. ge_port Specifies the GbE port to be displayed. On the Brocade 7500, 7500E, and FR4-18i, the GbE ports are numbered ge0 and ge1. On the Brocade 7800, ge0-ge5 are 1 Gbps Ethernet ports. On the FX8-24, there are 10 1 Gbps Ethernet ports numbered ge0-ge9, and there are two 10 1 Gbps Ethernet ports numbered xge0 and xge1. Use portCfgshow with one of the following options and optional arguments to display specific FCIP-related parameters configured for a GbE port: Fabric OS Command Reference 629 53-1001337-01