HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 880

2 switchCfgSpeed switchCfgSpeed Synopsis Configures the speed for all ports on a switch. switchcfgspeed speed Description Use this command to configure the port speed on a switch. This command sets the speed for all user ports. If any port on the switch is not capable of the specified speed setting, an error message is displayed for that port. The configuration is saved in nonvolatile memory and persists across switch reboots or power cycles. Use the portShow command to display actual port speed settings. Use the portCfgShow command to display user-configured speed settings. Notes This configuration cannot be set on VE_Ports or VEX_Ports. Speed configuration is not applicable to FCoE ports. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operand: speed Specifies the speed for all ports on a switch. This operand is required. Valid values are as follows: 0 Auto-sensing mode. The port automatically configures for the highest speed. 1 The port is set at a fixed speed of 1 Gbps. 2 The port is set at a fixed speed of 2 Gbps. 4 The port is set at a fixed speed of 4 Gbps. 8 The port is set at a fixed speed of 8 Gbps. Examples To set the auto-sensing mode for all ports on a switch: switch:admin> switchcfgspeed 0 Committing configuration...done. See Also portCfgSpeed, portShow 850 Fabric OS Command Reference 53-1001337-01