HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 626

2 portCfg To create a mirror port: switch:admin> portcfg mirrorport 2/4 --enable Please confirm enable of Mirror Port (Y,y,N,n): [n] y To configure a range of ports as RSCN-suppressed: switch:admin> portcfg rscnsupr 2/4-7 --enable To add an entry to the VLAN tag table: switch:admin> portcfg vlantag8/ge0 add 192.168.10.1 100 3 To delete the entry from the VLAN tag table: switch:admin> portcfg vlantag8/ge0 delete 192.168.10.1 100 To configure an FCIP Tunnel 1 with FICON XRC and FICON write Tape Pipelining emulation features enabled using all default parameter arguments: switch:admin> portcfg ficon ge0 1 -x 1 -w 1 Function Synopsis Commands supported only on the Brocade 7500/7500E switches portcfg inbandmgmt ge_port option arguments Description Use this command to configure IP addresses and routes for the CP or GbE port inband management interfaces on the Brocade 7500. Inband management allows a management station to communicate with the CP through GbE ports. Operands This command has the following operands: inbandmgmt Configures IP addresses and routes for the CP or GbE port inband management interfaces. Inband management allows a management station to communicate with the CP through GbE ports. Valid options and arguments for inbandmgmt are: ipaddrset cp | ge ip_address netmask Configures the IP address and netmask for a CP or a GbE inband management interface. This command requires specifying the type of interface (cp or ge), an IPv4 address, and the subnet mask. For each management interface, configure two IP addresses, one for the CP and one for the GbE port. ipaddrdel cp | ge ip_address Deletes the IP address for a CP or GE inband management interface. Specify the type of interface (cp or ge) and the IPv4 address to be deleted. cp | ge ip_address netmask Specifies the interface type as either CP or port processor. This operand is required when configuring or deleting an IP address. Specifies the IP address for the inband management interface. The IP address must be in IPv4 format, followed by the subnet mask. IPv6 addresses are not supported. This operand is required with the ipaddrset and ipaddrdel options. Specifies the subnet mask for the IP address in a.b.c.d format. This operand is required only with the ipaddrset option. 596 Fabric OS Command Reference 53-1001337-01