Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 105
Selecting the settings and functions
View all Kyocera KM-5530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
24 If there are no problems with the copy set you made, then you can use the repeat copy mode to make any additional number of copy sets as desired (see "(2) Printing out with the repeat copy mode" on page 5-44). (2) Selecting the settings and functions 1 Selecting the paper This procedure selects the size of the copy paper. 1 With the content of the "Basic" tab displayed, touch the "Select paper" key. The "Select paper" screen will be displayed. Inch specifications Ready to Job build. Place originals then press Start key. Job Build - Step1 11x81/2" Select paper None Finished Basic 1-sided Original type AMS Reduce /Enlarge Quality 1 sided copy 1 sided/ 2 sided Back Edge Orig. set direction Edit 1 sided copy-Left Finished page #:0 Set End Insert page Metric specifications Ready to Job build. Set original. Press Start key. Job Build-Step 1 Select paper None Finished Basic 1-sided Original type AMS Reduce/ Enlarge Quality 1-sided Copy 1-sided/ 2-sided Back Edge Orig. set direction Edit 1-sided Copy-Left Finished page #: 0 Set End Insert blank page 2 Touch the key that corresponds to the drawer[cassette] which contains the desired size of copy paper, and then touch the "Close" key. The touch panel will return to the screen in step 1. Inch specifications Ready to Job build. Place originals then press Start key. Select paper Back Set Close 11x81/2" Plain 11x81/2" Color 11x81/2" Plain 11x81/2" Plain Bypass Plain 11x81/2" Plain Metric specifications Ready to Job build. Set original. Press Start key. Select paper Back Set Close Plain Colour Plain Plain Bypass Plain Plain Section 5 OTHER CONVENIENT FUNCTIONS 2 Specifying the type of originals This procedure specifies the type of originals being copied between 1-sided, 2-sided and open-faced. 1 With the content of the "Basic" tab displayed, touch the "Original type" key. The "Original type" screen will be displayed. Inch specifications Ready to Job build. Place originals then press Start key. Job Build - Step1 11x81/2" Select paper None Finished Basic 1-sided Original type AMS Reduce /Enlarge Quality 1 sided copy 1 sided/ 2 sided Back Edge Orig. set direction Edit 1 sided copy-Left Finished page #:0 Set End Insert page Metric specifications Ready to Job build. Set original. Press Start key. Job Build-Step 1 Select paper None Finished Basic 1-sided Original type AMS Reduce/ Enlarge Quality 1-sided Copy 1-sided/ 2-sided Back Edge Orig. set direction Edit 1-sided Copy-Left Finished page #: 0 Set End Insert blank page 2 Select between "1 sided", "2 sided" and "Book", in accordance with the originals being copied. Inch specifications Ready to Job build. Place originals then press Start key. Original type 1 sided 2 sided Book Set Back Close Check direction Check direction of original top side. Rear Left top corner Metric specifications Ready to Job build. Set original. Press Start key. Original type 1 sided 2-sided Book Set Back Close Check direction Check direction of original. Back Edge Left top corner NOTES • If you selected "1 sided", verify the direction in which the originals were set. • If you selected "2 sided", specify the binding direction of the originals and then verify the direction in which the originals were set. • If you selected "Book", specify the binding direction of the originals. 3 Touch the "Close" key. The touch panel will return to the screen in step 1. 5-63