Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 53
Making copies with clean edges [Border erase modes]
View all Kyocera KM-5530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Section 5 OTHER CONVENIENT FUNCTIONS 6. Making copies with clean edges [Border erase modes] (1) Erasing blemishes from edges of copies (Sheet erase mode) Inch specifications With this mode, shadows, lines, etc., that occur around the edges of copies made from sheet originals can be erased. The width of the border to be erased can be set to any 1/8" increment between 1/8" and 3/4". A setting of "0" will result in no border being erased. (The width of the border that will be erased is shown as a in the illustration.) Metric specifications With this mode, shadows, lines, etc., that occur around the edges of copies made from sheet originals can be erased. The width of the border to be erased can be set to any 1 mm increment between 1 mm and 18 mm. A setting of "0" will result in no border being erased. (The width of the border that will be erased is shown as a in the illustration.) (2) Erasing blemishes from the edges and middle of copies made from books (Book erase mode) Inch specifications With this mode, you can make clean copies, even from thick books. The width of the outside border to be erased can be set to any 1/8" increment between 1/8" and 3/4". The width of the center area to be erased can be set to any 1/8" increment between 1/8" and 1 1/2". A setting of "0" will result in no border being erased. (The width of the outside border that will be erased is shown as a in the illustration, while the width of the center area is shown as b.) Metric specifications With this mode, you can make clean copies, even from thick books. The width of the outside border to be erased can be set to any 1 mm increment between 1 mm and 18 mm. The width of the center area to be erased can be set to any 1 mm increment between 1 mm and 36 mm. A setting of "0" will result in no border being erased. (The width of the outside border that will be erased is shown as a in the illustration, while the width of the center area is shown as b.) a a abcdefghijk abcdefghijk abcdefghijk abcdefghijk abcdefghijk abcdefghijk abcdefghijk abcdefghijk a b abcdefghijk abcdefghijk a abcdefghijk abcdefghijk abcdefghijk abcdefghijk abcdefghijk abcdefghijk abcdefghijk NOTE It is possible for you to change the default setting for the width of the erased border. (See "Erased border width" on page 7-56.) NOTE It is possible for you to change the default setting for the width of the erased borders. (See "Erased border width" on page 7-56.) 5-11