Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 220

Section 9 TROUBLESHOOTING Message Procedure Reference page "Place transparency in bypass." Load transparencies onto the multi-bypass tray. 3-4 ["Place transparencies on stack bypass."] "Check paper size." There is no paper loaded of a size that can be used in the currently selected mode. - Check the paper. "Reposition original." The orientation of the original and the selected paper are different. Change the - orientation of the original. If you press the [Start] key without changing the original, copying will be performed at a 100% (1:1) magnification ratio. "Check paper size. Copy paper is not the same size as original." ["Paper size in cassette differs from actual size. Check paper size in cassette."] Load paper of the size selected or change the selection for the paper size. 7-23 "Reposition original or change The orientation of the original and the selected paper are different. Change the - drawer." ["Reset original or select orientation of the original. another paper cassette."] "Check paper size in tray. Different Load paper of the size selected or change the selection for the paper size. - from original." ["Check paper size in cassette. Different from original."] "Reset originals in processor." Remove the originals from the Document Processor, stack them together cleanly and - reset them in their current order back in the Document Processor. "Reset all originals in processor." Remove the originals from the Document Processor and reset them in their original order - ["Reset originals in processor."] back in the Document Processor. "Press start key for job recovery." Copying will be resumed from the point it was stopped. Press the [Start] key. - ["Press Start key to resume copying."] "Too many pages in processor. The number of originals in the Document Processor has exceeded the acceptable limit. - _____:maximum capacity" Reset a lesser number of originals. ["Too many pages in the processor. _____:max. number of original."] "Original left on platen. Remove An original has been left on the platen or in the Document Processor. Remove the - original." ["Original is left on platen. original. Remove original."] "Reset all originals in Document Remove the originals from the Document Processor. - processor." ["Reset originals in Document processor."] "Remove originals from processor. Remove the originals from the Document Processor and set them one by one on the - Set mode is not available when platen. using Doc Processor." ["Remove originals from processor. The set mode is not available when using Doc Processor."] "Interrupt copying is not available for Interrupt copying is not possible. Use different originals or cancel the interrupt copying - this size." operation and try to copy again later. "These functions cannot be The function or mode that you just selected cannot be used in combination with the - combined." currently set function or mode. 9-2