Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 21

Section 3 PREPARATIONS 1. Loading paper Paper can be loading into 5 locations in this copier: the 4 drawers[cassettes] and the multi-bypass tray. (1) Note when adding paper After taking new paper out of its packaging, be sure to fan through them a few times to separate the sheets before loading the paper into a drawer[cassette] or setting the paper on the multi-bypass tray. IMPORTANT! Using special paper In this copier, the type of paper loaded in each drawer[cassette] and on the multi-bypass tray can be specified under "Paper type (drawer[cassette] No.1 - No. 5)" on page 7-24 and "(1) Paper size and type" on page 7-62, respectively. Among the special paper that can be use with this copier, there is a wide range in paper quality and construction especially in those types of paper noted below. For that reason, there is a greater possibility of problems occurring during copying with these type of paper. Whenever you do use such special paper as noted here, it is recommended that you first make a test copy and verify the results. • Preprinted • Label sheets*1 • Prepunched *1: When using label sheets, be absolutely certain that there is no possibility that the backing glue will come into contact with any part of the copier, and that none of the labels will come off the sheet during copying. If glue does happen to come into contact with the drum or rollers, or one of the labels comes off inside the copier, it can be the cause of major damage. (2) Loading paper into drawers[cassettes] No.1 and No.2 Up to 500 sheets of standard copy paper (75 g/m2 - 90 g/m2) or color paper can be loaded into each drawer[cassette]. Inch specifications Each drawer[cassette] can hold paper of any size between 5 1/2" x 8 1/2" and 11" x 17". Metric specifications Each drawer[cassette] can hold paper of any size between A5R and A3. IMPORTANT! • In metric specification copiers, the size of paper loaded in each drawer[cassette] must be specified under "Paper size (drawer[cassette] No.1 & No.2)" on page 7-23. • The type of paper loaded in each drawer[cassette] must be specified under "Paper type (drawer[cassette] No.1 - No.5)" on page 7-24. 1 Pull the drawer[cassette] out toward you as far as it will go. 2 Move the paper length guide plates to fit the length of the paper that is to be loaded in that drawer[cassette]. The paper sizes are marked on the bottom of the drawer[cassette]. 3-1