Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 15

Section 2 NAMES OF PARTS ‹, ·- ¤ › fi fl ‡ ⁄ Œ „ ´ ¤ Original size indicator lines (Be sure to align the original with these lines whenever setting an original on the platen.) ‹ Platen (Set originals here for copying. Lay originals face-down and align the edges with the size indicator lines located on the left and rear sides of the platen.) › Total counter (This counter displays the total number of copies made on the copier up to this point.) fi Main switch (Turn this switch ON ( | ) before copying.) fl Copy eject tray (Finished copies are ejected and stored on this tray. This tray may be optional equipment in certain countries or regions of purchase.) ‡ Fixing unit handle A (Operate this handle out if a paper misfeed occurs inside the copier.) - Transfer unit handle C (Operate this handle out if a paper misfeed occurs inside the copier.) · Transfer unit release lever B (Operate this lever when you need to pull out the transfer unit.) , Transfer unit (Pull this unit out if a paper misfeed occurs inside the copier.) Œ Duplex Unit (Pull this unit out if a paper misfeed occurs inside the copier.) „ Paper length guide release levers (Pinch these levers and adjust the guide plate to fit the length of the paper that is to be loaded in that drawer[cassette].) ´ Paper width guide release levers (Pinch these levers and adjust the guide plates to fit the width of the paper that is to be loaded in that drawer[cassette].) 2-3