Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 26

Section 3 PREPARATIONS 2. Setting originals (1) Setting originals in the Document Processor The Document Processor automatically feeds and scans each original, one by one, for copying. You can also have two-sided originals turned over automatically in order to make two-sided copies or separate copies from each side. 3 How to set originals in the Document Processor 1 Adjust the original insert guides to fit the size of the originals. 1 Cautions when using the Document Processor DO NOT set originals of the follow types in the Document Processor. In addition, when using perforated sheets or originals with punch holes, DO NOT insert the end with the perforations or holes first. • OHP film and other transparencies • Carbon paper, crumpled originals or originals with strong folds, and soft originals such as vinyl • Originals which are not rectangular, wet originals, and originals with adhesive tape or glue • Originals with clips or staples (In order to use such originals, remove the clips or staples and straighten any crumples or folds before using them. Failure to do so may cause originals to misfeed.) • Clippings or originals with very slippery surfaces • Originals with wet correction fluid • Originals with folds (If you must use such originals, smooth out the folded portions before setting them in the Document Processor. Failure to do so may cause originals to misfeed.) 2 Originals that can be set in the Document Processor • Sheet originals • Paper weight: One-sided originals: between 35 g/m2 - 160 g/m2 Two-sided originals: between 50 g/m2 - 120 g/m2 • Size: Max. 11" x 17" or A3 - Min. 5 1/2" x 8 1/2" or A5R • Number of sheets: 100 sheets (under 11" x 8 1/2" or A4 size [75 g/m2 or 80 g/m2]) 70 sheets (over 8 1/2" x 14" or B4 size [75 g/m2 or 80 g/m2]) 30 sheets (when using the auto selection mode) NOTE Before setting any new originals, remove any originals that are remaining on the original ejection table. If ejected originals are left on the original eject table, they may cause other originals to misfeed. 2 Arrange the originals in order and set them face up (first page face up for two-sided originals) onto the original table. Slide the leading edge of the originals all the way into the Document Processor, as far as they will go. * When setting large size originals such as 8 1/2" x 14", 11" x 17", B4 or A3, be sure to open the ejection extension. 3-6