Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 221

Section 9 TROUBLESHOOTING Message Procedure Reference page "Exceeds pre registered copying The number of copies made under your department ID-code has reached the limit that 7-8 quantity." ["Copy limit for this ID- was set under the copy management mode and copying is no longer possible with that code has been reached."] code. Use the copy management mode to clear the copy count. "Ready to copy. Add toner." There is insufficient toner left in the copier. Since only one copy can be made at a time in 3-8 this state, add toner as soon as possible. "Add toner to resume copying." There is insufficient toner left in the copier to make copies. Add toner immediately. 3-8 "Image cycle." ["Now adding toner."] Toner is now being added. Please wait until the operation is complete. - "Cannot use this paper for copying." Copying is not possible at the currently selected sizes. - "System error. Main switch off / on." An error has occurred. Turn the main switch OFF (O) and then back ON ( | ) again. - "Disconnect power plug from the An error has occurred. Remove the power plug from the outlet. - socket." "Call service." Open and then close the front cover. If this message still remains, make a note of the - number that displayed with the "C", turn the main switch OFF (O), remove the power plug from the outlet and contact your service representative or authorized service center. "Time for maintenance" Periodic maintenance is required to keep your copier in good condition. Contact your - service representative or authorized service center as soon as possible. "Check KMAS." An error has occurred. Contact your service representative or authorized service center. - "Time for replacing Felt Roller." It is time to replace certain parts in your copier. Contact your service representative or - ["Felt cleaning maintenance."] authorized service center. "Call for service to replace Felt It is time to replace certain parts in your copier. Contact your service representative or - Roller." ["Change felt clean.-(F.unit)"] authorized service center. "Insert key counter." Insert the Key Counter securely into its opening. 8-7 "Memory full." The copier's memory is full. Select whether you want to print out that data that is already - scanned or delete all of that data. It will not be possible to copy or scan another original until one of these two operations is performed. "Paper misfeed. Remove paper." If paper misfeeds, the location of the misfeed will be indicated on the touch panel. Leave 9-6 the main switch ON ( | ) and follow the appropriate procedure to remove the jammed paper. "Attach Side Paper Deck to Attach the optional Side Feeder securely to the copier. - Mainframe." ["Attach side feeder to main frame."] "Paper capacity exceeded. Remove The number of sheets of paper loaded in the optional Side Feeder has exceeded the 3-5 paper from Side Paper Deck." acceptable limit. Load paper only up to the acceptable limit. ["Paper capacity exceeded. Remove paper from side feeder."] "Finisher is out of order. Press "Continue" to resume job" The optional Document Finisher is out of order and cannot be used for the moment. - Contact your service representative or an authorized service center as soon as possible. 9-3