Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 153

Section 7 COPIER MANAGEMENT FUNCTIONS Default setting Description Available settings Paper type (drawer[cassette] No.1 No. 5) Sets and then displays the type of paper that is loaded in drawers[cassettes] No.1 through No.5. * The drawer[cassette] No.5 setting will only be displayed when the optional Side Feeder, which is only available for 55 cpm copiers, is installed on your copier. Plain Preprinted Recycled Letterhead Color [Colour] Prepunched Rough Bond Custom 1 - Custom 8 Custom paper type for 2-sided copying Sets whether or not each custom paper type (custom 1 custom 8) will be available for use in 2-sided copying. On / Off Factory setting Plain Reference page 7-24 On 7-25 Paper type (for used If a white band (unprinted area) appears on copies On / Off Off paper) parallel to their direction of ejection when using paper which has already been copied onto or used previously, it is possible to minimize the negative effect of this white area. This setting is applicable to each "custom" paper type setting ("custom 1" through "custom 8"). * The "Paper type (for used paper)" and "Paper type (for high-resistance paper)" settings cannot be used in combination with each other. The setting that was made most recently will be in effect for the corresponding "custom" paper type. 7-26 Paper type (for high- If a white band (unprinted area) appears on copies On / Off Off resistance paper) parallel to their direction of ejection when using high- resistance paper (paper with a high-resistance surface such as that used for both color and monochrome copying), it is possible to minimize the negative effect of this white area. This setting is applicable to each "custom" paper type setting ("custom 1" through "custom 8"). * The "Paper type (for high-resistance paper)" and "Paper type (for used paper)" cannot be used in combination with each other. The setting that was made most recently will be in effect for the corresponding "custom" paper type. 7-27 Auto shut-off time Sets the amount of time that will elapse after copying, or if no operation is performed, before the auto shut-off function engages and turns the copier OFF. * It is recommended that you try to set a longer time interval before auto shut-off engages if you use the copier frequently, and to a shorter time if there are long intervals between use. 15 - 240 (minutes) 90 (minutes) 7-27 Auto preheat time Sets the amount of time between the point that copying ends and the energy-saving preheat mode engages. 1 - 45, 60, 90, 120, 180 and 240 (minutes) 15 (minutes) 7-28 7-19