Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 27

IMPORTANT! DO NOT set more originals than indicated on the sticker that is attached to the rear original insert guide. If more than the acceptable number of originals is set, the originals may not feed properly. Section 3 PREPARATIONS 3 Hold the Document Processor handle and close the Document Processor. * Leave the Document Processor open whenever you are using an original that is over 4 cm thick. IMPORTANT! Avoid placing excessive pressure on the platen when closing the Document Processor. Too much pressure on the platen may cause the glass to break. (2) Setting originals on the platen To make copies from originals that cannot be set in the Document Processor (books, magazines, etc.), lift open the Document Processor and set one original at a time on the platen. 1 Hold the Document Processor handle and lift the Document Processor open. * Before opening the Document Processor, remove any originals that are on the original table and the original eject table to prevent them from falling off the Document Processor when it is opened. NOTE When copying from open-faced originals (books, etc.), shadows may appear around the outside edges of, or up the middle between, the copy images. CAUTION DO NOT leave the document processor open as there is a danger of personal injury. 2 Set the original face down on the platen and align it with the appropriate original size indicator lines on the left side of the platen. 3-7