Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 237

Section 9 TROUBLESHOOTING 4. If other trouble occurs If trouble occurs with your copier, carry out the applicable checkpoints and procedures indicated on the following pages. If the trouble persists, contact your service representative or authorized service center. Trouble Checkpoint Nothing lights on the operation panel when the main switch is turned ON. Is the power plug connected to an AC outlet? Procedure Connect the plug to an AC outlet. Reference page -- No copies come out when Is there an error message on the touch Check the appropriate response to that 9-1 the [Start] key is pressed. panel? message, and perform the corresponding procedure. The copies come out blank. Were the originals set correctly? When setting originals on the platen, set 3-7 them face-down. When setting originals in the Document 3-6 Processor, set them face-up. The copies come out too light. Is the copier in the auto exposure mode? In order to adjust the overall exposure level, perform the "Auto exposure adjustment" procedure. 7-50 Is the copier in the manual exposure mode? Adjust the exposure to the correct level 4-2 using the copy exposure adjustment keys. To adjust the overall exposure, adjust the exposure for each image quality mode. 7-52 7-53 7-54 Is a message that tells you to add toner Add toner. 3-8 displayed? Is the copy paper wet? Replace the copy paper with new paper. 3-1 The copies come out too dark. Is the copier in the auto exposure mode? In order to adjust the overall exposure level, perform the "Auto exposure adjustment" procedure. 7-50 Is the copier in the manual exposure mode? Adjust the exposure to the correct level 4-2 using the copy exposure adjustment keys. The copies are dirty. To adjust the overall exposure, adjust the exposure for each image quality mode. Is the platen or the Document Processor dirty? Clean the platen and/or the Document Processor. 7-52 7-53 7-54 10-1 9-19