Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 152

Section 7 COPIER MANAGEMENT FUNCTIONS 3. Default settings The state that the copier enters at the end of warm-up or when the [Reset] key is pressed is called the "initial mode". The modes, functions and other settings that are automatically pre-set for the initial mode are called "default settings". These default settings are separated into two categories: "Copy defaults" and "Machine defaults" and can be changed as desired to suit your copying needs. (1) Machine default settings The following table indicates the machine default settings available in this copier. Change any or all of the settings as desired in order to make the most effective use of your copier. Default setting Description Available settings Factory setting Reference page Auto drawer[cassette] If the paper in one drawer[cassette] runs out during On / Off On switching ON/OFF copying, the automatic drawer[cassette] switching function will switch paper feed from the empty drawer[cassette] to another drawer[cassette] that contains the same size of paper in the same orientation for uninterrupted copying. To enable this function, it is necessary to turn the related setting "On". 7-22 In order to prevent a drawer[cassette] that holds a different type of paper from being switched to when the automatic drawer[cassette] switching function is turned ON, it is necessary to select "Feed same paper type" as well. All types of paper / Feed same paper type All types of paper Paper size (drawer[cassette] No.1 & No.2) • Inch specification copiers Sets the size of paper that is loaded in drawers[cassettes] No.1 and No.2. If you want the size to be detected automatically, select "Auto Detection" (Automatic size detection). If you want to manually set the size of paper, select "Standard sizes". Auto Detection / Standard sizes Auto Detection 7-23 Inch Inch You can also select the desired unit of measurement: Centimeter "Inch" or "Centimeter". You can then select the paper size. A3 --- A4 A4R A5R B4 B5 B5R Folio 11 x 17 8 1/2 x 14 11 x 8 1/2 8 1/2 x 11 5 1/2 x 8 1/2 8 1/2 x 13 7-18 • Metric specification copiers Sets the size of paper that is loaded in drawers[cassettes] No.1 and No.2. You can then select the paper size. A3 A4 A4 A4R A5R B4 B5 B5R Folio 11 x 17 8 1/2 x 14 11 x 8 1/2 8 1/2 x 11 5 1/2 x 8 1/2 8 1/2 x 13