Kyocera KM-5530 KM/Ri 4530/5530 Operation Guide Rev 5F - Page 66

Section 5 OTHER CONVENIENT FUNCTIONS 7 Touch the "Saddle stitch" key or the "Bind & Fold" key, as appropriate. * It is possible for you to center staple, or center staple and fold, up to 16 copy sheets (64 layout pages) at one time. Inch specifications Set first page. Press "Start" key. Saddle Stitch Pape Set 81/2x11" 100% Back Close Off Saddle stitch Bind & Fold Metric specifications Duplex Mode. Saddle Stitch Paper size Set Back Close Off Saddle Stitch Bind & Fold NOTE The "Bind & Fold" key will only be displayed when the optional Center-Folding Unit is installed on your copier. 8 If you want to add covers, touch the "Stitching Front cvr" ["Stitching Front cov."] key and go to the next step. If you do NOT want to add covers, go directly to step 10. Inch specifications 2 sided mode. Paper size Set 11x81/2" Booklet None Booklet Book ➔Booklet Original 1-sided 2-sided Left/Right 2-sided Top/Bottom Finishing Open from left Open from right Open from top Register Stitching Off Stitching Front cvr Saddle Stitch Back Close Check direction Check direction of original top side. Rear Left top corner Metric specifications Duplex Mode. Booklet None Booklet Book RBooklet Original 1-sided 2-sided Left/Right 2-sided Top/Bottom Finished Left binding Right binding Top binding Register Stitching Off Stitching Front cov. Center Staple Paper size Set Back Close Check direction Check direction of original. Back Edge Left top corner 9 Touch the "Cover" key and select whether or not (and where) to copy on each of the front and back covers. Inch specifications 2 sided mode. Paper size Set 11x81/2" Front cover Front cover Back Rear cover Close No cover Cover Blank Front copy Back copy 2 sided copy Blank Front copy Back copy 2 sided copy Metric specifications Duplex Mode. Stitching Front cover. Front cover No cover Cover Blank Front copy Back copy 2-sided copy Paper size Set Back Back cover Close Blank Front copy Back copy 2-sided copy 10 Press the [Start] key. Scanning of the originals will start. If you set the originals in the Document Processor, copying will start automatically. If you set an original on the platen, a message will appear telling you to set the next original. In this case, go to the next step. 11 Replace the first original with the next one and press the [Start] key. Scanning of that next original will start. 12 Once you have finished scanning all of the originals, touch the "Scanning finished" key. Copying will start. 5-24