Canon XF605 Instruction Manual - Page 121

Custom Picture Settings Resetting Custom Picture Files 1 Select a custom picture file (A 119). 2 Select > [/ Custom Picture] > [Edit / File] > [Reset]. 3 Select a preset custom picture setting and then select [OK]. • The custom picture file will be reset to the selected values. 121 Look Files You can register 3D LUT files (.cube format) created with Blackmagic Design's DaVinci Resolve or other software as Look Files in the custom picture file. Using a Look File allows you to adjust the video quality of the recorded video. These adjustments apply also to proxy clips, photos, and screen/output terminals. 1 Insert the SD card with the desired Look File (.cube format, located in the root directory of the SD card) into the camera's SD card slot B. 2 Select a custom picture file. (A 119) 3 Select > [/ Custom Picture] > [Edit / File] > [Gamma/Color Space] > Desired option. 4 Select > [/ Custom Picture] > [Edit / File] > [Look File Setup] > [Register]. • The Look Files in the SD card will be displayed. 5 Select the desired Look File. 6 Select the [Gamma/Color Space] setting to use after the Look File is applied. 7 Select [OK] twice. • The selected Look File will be loaded and registered to the custom picture file. • The image quality adjustments set in the Look File will be applied, and will appear on the screen. • When disabling the image quality adjustments set in the Look File, select [Edit / File] > [Look File] > [Off]. > [/ Custom Picture] > NOTES About Look files - The camera supports Look Files (.cube format) in 17 grid or 33 grid format created with Blackmagic Design's DaVinci Resolve or other software. - Look Files with input ranges outside the 0 to 1 range in the header ("LUT_3D_INPUT_RANGE") are not supported. - Look Files 2 MB and larger, as well as files with a name containing over 65 characters are not supported. - Only the following characters can be used in the file name: Numbers 0 to 9, upper/lower case letters a to z, underscore (_), hyphen (-), period (.) and a single byte space. • If the correct input/output gamma curve and color space conversion are not selected, video will not be output correctly. • A Look File cannot be used if the [Gamma/Color Space], [HLG Color] or [Over 100%] settings are changed after registering it. • When the gamma curve component of the [Gamma/Color Space] setting in the custom picture is set to either [BT.709 Normal], [BT.709 Standard] or [BT.709 Wide DR], super-white (video signal above 100%) and super- black (video signal below 0%) levels of brightness will be clipped. When the video signal contains super-white brightness levels, select > [/ Custom Picture] > [Edit / File] > [Other Functions] > [Over 100%] > [Press] and then activate the Look File to apply it to a signal compressed to 100%.