Canon XF605 Instruction Manual - Page 175

IP Streaming IP Streaming In CAMERA mode, you can stream the camera's live video and audio over IP to a compatible IP video decoder* connected to the network. You can use IP streaming for live broadcasts or to send video reports from a location with poor network connectivity. * This can be a dedicated video transfer device or decoder software on a computer. For details about compatible decoders, please visit your local Canon website. 175 Configuration of video streamed over IP Main recording video configuration Video format Resolution Frame rate XF-AVC, MP4 (H.264) 3840x2160, 1920x1080 59.94P 59.94i 50.00P 50.00i Bit rate 9 Mbps, 4 Mbps, Streamed video configuration Video Audio Resolution Frame rate Audio format Bit rate 59.94P, 59.94i 1920x1080 59.94i MPEG-2 AAC 50.00P, 50.00i 2 channels* 256 Kbps 50.00i * When the audio of the primary clip uses 4 channels, you can select which channels to stream over IP. 1 On the receiver's side: Connect the decoder to the network and complete any necessary configurations so it is ready to receive video over IP. • For details refer to the instruction manual of the decoder device or software you will use. 2 On the camera: Connect the camera to the desired network and activate the network functions (A 160). • Select a connection setting with the [IP Streaming] function setting. 3 Select > [ Network Settings] > [Activate IP Streaming] > [Enable]. • The camera will start streaming video over the selected network. • You can press the REC button to simultaneously record the same image in the camera. 4 On the receiver's side: Only when the streaming protocol is [RTSP+RTP], access the following URL and log in using the RTSP user name and password (A 163). rtsp://xxx.xxx.xxx.xxx/stream Camera's IP address 5 On the camera: To end the streaming, select Streaming] > [Disable]. > [ Network Settings] > [Activate IP IMPORTANT • Streamed data is not encrypted. NOTES • Except when the streaming protocol is [RTSP+RTP], once IP streaming is activated, the camera will continue to broadcast video and audio data over the network, regardless of the status of the receiver. Be careful to set up the correct IP address and test in advance that the receiving decoder can indeed receive the signals. • Depending on the network used and the connection conditions, you may experience lost or delayed IP packets. • After streaming continuously for 24 hours, the camera will stop the IP streaming momentarily and then restart it automatically. • When using IP streaming together with the Browser Remote function, you may experience stuttering issues in the streamed video or audio. When the two functions are used simultaneously, it is recommended not to log out from/reconnect to Browser Remote.