Dell PowerEdge T140 EMC PowerEdge Servers Troubleshooting Guide - Page 128
Symptoms, Linux, FAQs, Installing operating system through various methods
View all Dell PowerEdge T140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Symptoms Dell PowerEdge Express Flash NVMe PCIe SSD device is not detected during hot-plug in ESXi 6.0 Description When the Express Flash NVMe PCIe SSD namespace is set as Offline and hot-plug operation is performed in the same slot, the SSD does not initialize and is not detected. This is a known issue. Perform one of the following steps: 1 Reconnect the drive to a different drive slot, if available. 2 Restart the sfcbd-watchdog service and reinsert the drive. Linux FAQs Why are network ports displayed as unknown in YaST2 network configuration in SUSE Linux Enterprise? While configuring a bonding interface, the configured bond-slaves are listed as Unknown Network Device. The YaST installer is unable to write the device name in to the ifcfg files. Delete the existing configuration of previously configured network interfaces. Symptoms Unable to boot from iSCSI when static IPv6 address is assigned to the initiator Description The SUSE Linux Enterprise Server 12 does not boot from iSCSI over IPv6 address after successful installation, when static IPv6 address is assigned to the initiator. Resolution Use Dynamic Host Configuration Protocol (DHCP) address for the initiator. Installing operating system through various methods Install and deploy operating system through Dell Lifecycle Controller and various methods, watch the following videos listed below: 128 Troubleshooting operating system issues