Dell PowerEdge T140 EMC PowerEdge Servers Troubleshooting Guide - Page 84
Configuring RAID by using Lifecycle Controller, Configuring
View all Dell PowerEdge T140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
The log is created with the name: #### MegaSAS.log Figure 22. Log creation 8 Copy MegaSAS.log to datastore by using command:cp /opt/lsi/perccli/MegaSAS.log /vmfs/volumes/datastore1/ 9 Copy the file to desktop with Datastore Browser. Figure 23. Log file in Datastore Browser Now the logs are exported on ESXi hosts on the Dell 13th generation PowerEdge servers. Configuring RAID by using Lifecycle Controller Prerequisite If your system has one or more supported PERC RAID controllers with PERC 8 firmware or later, or software RAID controllers, use the RAID Configuration wizard to configure a virtual disk as the boot device. NOTE: Create boot virtual disk only from a disk drive populated across slots 0-3 of the system. For slot information, see the server Owner's Manual at Dell.com/poweredgemanuals. 84 Troubleshooting hardware issues