Dell PowerEdge T140 EMC PowerEdge Servers Troubleshooting Guide - Page 18
uSATA SSD indicator codes, Internal dual SD module indicator codes
View all Dell PowerEdge T140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
uSATA SSD indicator codes Figure 8. uSATA SSD indicators 1 uSATA SSD activity indicator 3 uSATA SSD 2 uSATA SSD status indicator NOTE: If the SSD is in the Advanced Host Controller Interface (AHCI) mode, the status indicator (on the right side) does not function and remains off. Table 11. Drive status indicator codes Drive-status indicator pattern Flashes green twice per second Off Condition Identifying drive or preparing for removal. Drive ready for insertion or removal. NOTE: The drive status indicator remains off until all hard drives are initialized after the system is turned on. Drives are not ready for insertion or removal during this time. Flashes green, amber, and turns off Predicted drive failure. Flashes amber four times per second Drive failed. Steady green Drive online. Flashes green for three seconds, amber for three seconds, and Rebuild stopped. turns off after six seconds Internal dual SD module indicator codes The Internal Dual SD module (IDSDM) provides you with a redundant SD card solution. You can configure the IDSDM for storage or as the OS boot partition. The IDSDM card offers the following features: • Dual card operation - maintains a mirrored configuration by using SD cards in both the slots and provides redundancy. NOTE: When the Redundancy option is set to Mirror Mode in the Integrated Devices screen of System Setup, the information is replicated from one SD card to another. • Single card operation - single card operation is supported, but without redundancy. The following table describes the IDSDM indicator codes: 18 Diagnostic indicators