Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 116

ProSafe Managed Switch no storm-control unicast level This command sets the unicast storm recovery threshold to the default value and disables unicast storm recovery for all interfaces. Format Mode no storm-control unicast level Global Config storm-control unicast rate (Global) Use this command to configure the unicast storm recovery threshold for all interfaces in packets per second. If the mode is enabled, unicast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured threshold. Default Format Mode 0 storm-control unicast rate Global Config no storm-control unicast rate This command sets the multicast storm recovery threshold to the default value for an interface and disables multicast storm recovery. Format Mode no storm-control unicast rate Global Config storm-control flowcontrol This command enables 802.3x flow control for the switch and only applies to full-duplex mode ports. Note: 802.3x flow control works by pausing a port when the port becomes oversubscribed and dropping all traffic for small bursts of time during the congestion condition. This can lead to high-priority and/or network control traffic loss. Default Format Mode disabled storm-control flowcontrol Global Config Switching Commands 116