Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 117

ProSafe Managed Switch no storm-control flowcontrol This command disables 802.3x flow control for the switch. Note: This command only applies to full-duplex mode ports. Format Mode no storm-control flowcontrol Global Config show storm-control This command displays switch configuration information. If you do not use any of the optional parameters, this command displays global storm control configuration parameters: • Broadcast Storm Control Mode may be enabled or disabled. The factory default is disabled. • 802.3x Flow Control Mode may be enabled or disabled. The factory default is disabled. • Broadcast Storm Control Level The broadcast storm control level. The factory default is 5%. • Multicast Storm Control Mode may be enabled or disabled. The factory default is disabled. • Multicast Storm Control Level The multicast storm control level. The factory default is 5%. • Unicast Storm Control Mode may be enabled or disabled. The factory default is disabled. • Unicast Storm Control Level The unicast storm control level. The factory default is 5%. Use the all keyword to display the per-port configuration parameters for all interfaces, or specify the unit/slot/port to display information about a specific interface. Format Mode show storm-control [all | ] Privileged EXEC Term Bcast Mode Bcast Level Mcast Mode Mcast Level Definition Shows whether the broadcast storm control mode is enabled or disabled. The factory default is disabled. The broadcast storm control level. Shows whether the multicast storm control mode is enabled or disabled. The multicast storm control level. Switching Commands 117