Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 235

ProSafe Managed Switch no arp timeout This command configures the default ARP entry ageout time. Format Mode no arp timeout Global Config clear arp-cache This command causes all ARP entries of type dynamic to be removed from the ARP cache. If the gateway keyword is specified, the dynamic entries of type gateway are purged as well. Format Mode clear arp-cache [gateway] Privileged EXEC clear arp-switch Use this command to clear the contents of the switch's Address Resolution Protocol (ARP) table that contains entries learned through the Management port. To observe whether this command is successful, ping from the remote system to the DUT. Issue the show arp switch command to see the ARP entries. Then issue the clear arp-switch command and check the show arp switch entries. There will be no more arp entries. Format Mode clear arp-switch Privileged EXEC show arp This command displays the Address Resolution Protocol (ARP) cache. The displayed results are not the total ARP entries. To view the total ARP entries, the operator should view the show arp results in conjunction with the show arp switch results. Format Mode show arp Privileged EXEC Term Age Time (seconds) Response Time (seconds) Retries Cache Size Dynamic Renew Mode Definition The time it takes for an ARP entry to age out. This is configurable. Age time is measured in seconds. The time it takes for an ARP request timeout. This value is configurable. Response time is measured in seconds. The maximum number of times an ARP request is retried. This value is configurable. The maximum number of entries in the ARP table. This value is configurable. Displays whether the ARP component automatically attempts to renew dynamic ARP entries when they age out. Routing Commands 235