Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 504

ProSafe Managed Switch no boot host retry-count This command is used to reset the number to the default. The default number is 3. Format Mode no boot host retry-count Privileged EXEC boot host dhcp This command is used to enable AutoInstall on the switch for the next reboot cycle. The command does not change the current behavior of AutroInstall and saves the command to NVRAM. Default Format Mode Enabled3 boot host dhcp Privileged EXEC no boot host dhcp This command is used to disable AutoInstall on the switch for the next reboot cycle. The command does not change the current behavior of AutroInstall and saves the command to NVRAM Format Mode no boot host dhcp Privileged EXEC Dual Image Commands The software supports a dual image feature that allows the switch to have two software images in the permanent storage. You can specify which image is the active image to be loaded in subsequent reboots. This feature allows reduced down-time when you upgrade or downgrade the software. delete This command deletes the supplied image file from the permanent storage. The image to be deleted must be a backup image. If this image is the active image, or if this image is activated, an error message displays. The optional parameter is valid only on Stacks. Error will be returned, if this parameter is provided, on Standalone systems. In a stack, the parameter identifies the node on which this command must be executed. When this parameter is not supplied, the command is executed on all nodes in a Stack. Format Mode delete [] {image1 | image2} Privileged EXEC Utility Commands 504