Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 31

ProSafe Managed Switch continues to be forwarded in hardware while the management functions initialize on the backup unit. NSF is enabled by default on platforms that support it. The administrator can disable NSF to redirect the CPU resources consumed by data checkpointing. If a unit that does not support NSF is connected to the stack, then NSF is disabled on all stack members. If a unit that does not support NSF is disconnected from the stack and all other units support NSF, and NSF is administratively enabled, then NSF operation resumes. Default Format Mode Enabled nsf Stack Global Config no nsf This command disables non-stop forwarding on the stack. Format Mode no nsf Stack Global Config show nsf This command displays global and per-unit information on NSF configuration on the stack. Format Mode show nsf Privileged EXEC Term NSF Administrative Status NSF Operational Status Last Startup Reason Time Since Last Restart Time Restart in progress Definition Whether nonstop forwarding is administratively enabled or disabled. Default: Enabled Indicates whether NSF is enabled on the stack. The type of activation that caused the software to start the last time: • "Power-On" means that the switch rebooted. This could have been caused by a power cycle or an administrative "Reload" command. • "Administrative Move" means that the administrator issued the movemanagement command for the stand-by manager to take over. • "Warm-Auto-Restart" means that the primary management card restarted due to a failure, and the system executed a nonstop forwarding failover. • "Cold-Auto-Restart" means that the system switched from the active manager to the backup manager and was unable to maintain user data traffic. This is usually caused by multiple failures occurring close together. The time since the current management unit became the active management unit. Whether a restart is in progress. Stacking Commands 31