Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 482

ProSafe Managed Switch If an IPv6 ACL by this name already exists, this command enters IPv6-Access-List config mode to allow updating the existing IPv6 ACL. Note: The CLI mode changes to IPv6-Access-List Config mode when you successfully execute this command. Format Mode ipv6 access-list Global Config no ipv6 access-list This command deletes the IPv6 ACL identified by from the system. Format Mode no ipv6 access-list Global Config ipv6 access-list rename This command changes the name of an IPv6 ACL. The parameter is the name of an existing IPv6 ACL. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 access list. This command fails is an IPv6 ACL by the name already exists. Format Mode ipv6 access-list rename Global Config {deny | permit} (IPv6) This command creates a new rule for the current IPv6 access list. Each rule is appended to the list of configured rules for the list. Note: The 'no' form of this command is not supported, since the rules within an IPv6 ACL cannot be deleted individually. Rather, the entire IPv6 ACL must be deleted and respecified. Note: An implicit 'deny all' IPv6 rule always terminates the access list. Quality of Service (QoS) Commands 482