Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 23

ProSafe Managed Switch Format Mode switch renumber Global Config movemanagement This command moves the Primary Management Unit functionality from one switch to another. The is the switch identifier on the current Primary Management Unit. The is the switch identifier on the new Primary Management Unit. Upon execution, the entire stack (including all interfaces in the stack) is unconfigured and reconfigured with the configuration on the new Primary Management Unit. After the reload is complete, all stack management capability must be performed on the new Primary Management Unit. To preserve the current configuration across a stack move, execute the copy system:running-config nvram:startup-config (in Privileged EXEC) command before performing the stack move. A stack move causes all routes and layer 2 addresses to be lost. This command is executed on the Primary Management Unit. The system prompts you to confirm the management move. Note: The movemanagement command does not NSF (non-stop forwarding). To move the management unit to the backup unit, use initiate failover instead. For more information, see initiate failover on page 32. Format Mode movemanagement Stack Global Config standby Use this command to configure a unit as a Standby Management Unit (STBY). Format Mode standby Stack Global Config Note: The Standby Management Unit cannot be the current Management Unit. The Standby unit should be a management-capable unit. slot This command configures a slot in the system. The is the slot identifier of the slot. The is the index into the database of the supported card types, Stacking Commands 23