Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 30

ProSafe Managed Switch Term Unit Interface Tx Data Rate Tx Error Rate Tx Total Error Rx Data Rate Rx Error Rate Rx Total Errors Definition The unit number. The slot and port numbers. Trashing data rate in megabits per second on the stacking port. Platform-specific number of transmit errors per second. Platform-specific number of total transmit errors since power-up. Receive data rate in megabits per second on the stacking port. Platform-specific number of receive errors per second. Platform-specific number of total receive errors since power-up. show stack-port diag This command shows front panel stacking diagnostics for each port and is only intended for Field Application Engineers (FAEs) and developers. An FAE will advise on the necessity to run this command and capture this information. Format Mode show stack-port diag Privileged EXEC Term Unit Interface Diagnostic Entry1 Diagnostic Entry2 Diagnostic Entry3 Definition The unit number. The slot and port numbers. 80 character string used for diagnostics. 80 character string used for diagnostics. 80 character string used for diagnostics. Non-Stop Forwarding Commands Non-stop forwarding allows the stack units to continue to forward packets if the stack management unit restarts because of a power failure, hardware failure, or software fault. nsf Use this command to enable nonstop forwarding feature on the stack. When nonstop forwarding is enabled, if the management unit of a stack fails, the backup unit takes over as the master without clearing the hardware tables of any of the surviving units. Data traffic Stacking Commands 30