Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 242

ProSafe Managed Switch they were assigned the original default distance. The new default distance will only be applied to static routes created after invoking the ip route distance command. Default Format Mode 1 ip route distance Global Config no ip route distance This command sets the default static route preference value in the router. Lower route preference values are preferred when determining the best route. Format Mode no ip route distance Global Config ip netdirbcast This command enables the forwarding of network-directed broadcasts. When enabled, network directed broadcasts are forwarded. When disabled they are dropped. Default Format Mode disabled ip netdirbcast Interface Config no ip netdirbcast This command disables the forwarding of network-directed broadcasts. When disabled, network directed broadcasts are dropped. Format Mode no ip netdirbcast Interface Config ip mtu This command sets the IP Maximum Transmission Unit (MTU) on a routing interface. The IP MTU is the size of the largest IP packet that can be transmitted on the interface without fragmentation. The software currently does not fragment IP packets. • Packets forwarded in hardware ignore the IP MTU. • Packets forwarded in software are dropped if they exceed the IP MTU of the outgoing interface. Packets originated on the router, such as OSPF packets, may be fragmented by the IP stack. The IP stack uses its default IP MTU and ignores the value set using the ip mtu command. Routing Commands 242