Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 428

ProSafe Managed Switch Term Definition Next Bootstrap Message In Time (in hours, minutes, and seconds) in which the next bootstrap message is due from this BSR. Next Candidate RP advertisement in Time (in hours, minutes, and seconds) in which the next candidate RP advertisement will be sent. show ipv6 pim rp-hash Use this command to display which rendezvous point (RP) is being used for a specified group. Format Modes show ipv6 pim rp-hash • Privileged EXEC • User EXEC Term RP Origin Definition The IP address of the RP for the group specified. Indicates the mechanism (BSR or static) by which the RP was selected. show ipv6 pim rp mapping Use this command to display all group-to-RP mappings of which the router is aware (either configured or learned from the bootstrap router (BSR)). If no RP is specified, all active RPs are displayed. Format Modes show ipv6 pim rp mapping [rp address] • Privileged EXEC • User EXEC IPv6 MLD Commands IGMP/MLD Snooping is Layer 2 functionality but IGMP/MLD are Layer 3 multicast protocols. It requires that in a network setup there should be a multicast router (which can act as a querier) to be present to solicit the multicast group registrations. However some network setup does not need a multicast router as multicast traffic is destined to hosts within the same network. In this situation, the 7000 series has an IGMP/MLD Snooping Querier running on one of the switches and Snooping enabled on all the switches. For more information, see IGMP Snooping Configuration Commands on page 161 and MLD Snooping Commands on page 172. IPv6 Multicast Commands 428