Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 658

ProSafe Managed Switch Switch Database Management (SDM) Templates You can use SDM templates to configure system resources in the switch and optimize support for specific features depending on how the switch is used in the network. You can select a template to provide the maximum system usage for a specific function. For example, you could use a routing template to optimize resources for IPv4 routing if the network environment does not use IPv6 routing. Note the following: • If you configure an SDM template, you must reload the switch for the configuration to take effect. • If you try to configure IPv6 routing without first selecting the dual IPv4-IPv6 routing template, a warning message appears. sdm prefer Use this command to specify the SDM template to use on the switch. Default Format Mode ipv4-routing for IPv4 only builds, dual-ipv4-ipv6 for IPv6 builds sdm prefer {ipv4-routing {default | data-center} | dual-ipv4-and-ipv6 {default}} Global Config Parameter Description ipv4-routing Supports IPv4 routing only. -data-center: Support more ECMP next hops in IPv4 routes. -default: The routing template maximizes system resources for unicast routing, typically required for a router in the center of a network. dual-ipv4-and-ipv 6 Supports both IPv4 and IPv6 routing. This option is visible only when the switch supports IPv6 and IPv4 routing. -default: Balance IPv4 and IPv6 Layer 2 and Layer 3 functionality. no sdm prefer Use this command to return to the default template. Format Mode no sdm prefer Global Config show sdm prefer Use this command to view the currently active SDM template and its scaling parameters, or to view the scaling parameters for an inactive template. When used with no optional keywords, this command lists the currently active template and the template that will become Management Commands 658