Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 49

ProSafe Managed Switch spanning-tree edgeport This command specifies that this port is an Edge Port within the common and internal spanning tree. This allows this port to transition to Forwarding State without delay. Default Format Mode enabled spanning-tree edgeport Interface Config no spanning-tree edgeport This command specifies that this port is not an Edge Port within the common and internal spanning tree. Format Mode no spanning-tree edgeport Interface Config spanning-tree forceversion This command sets the Force Protocol Version parameter to a new value. Default Format Mode 802.1s spanning-tree forceversion Global Config • Use 802.1d to specify that the switch transmits ST BPDUs rather than MST BPDUs (IEEE 802.1d functionality supported). • Use 802.1s to specify that the switch transmits MST BPDUs (IEEE 802.1s functionality supported). • Use 802.1w to specify that the switch transmits RST BPDUs rather than MST BPDUs (IEEE 802.1w functionality supported). no spanning-tree forceversion This command sets the Force Protocol Version parameter to the default value. Format Mode no spanning-tree forceversion Global Config Switching Commands 49