Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 333

ProSafe Managed Switch Parameters hash-mask length bar-priority Description Length of a mask (32 bits maximum) that is to be ANDed with the group address before the hash function is called. All groups with the same seed hash correspond to the same RP. For example, if this value was 24, only the first 24 bits of the group addresses matter. This allows you to get one RP for multiple groups. Priority of the candidate BSR. The range is an integer from 0 to 255. The BSR with the larger priority is preferred. If the priority values are the same, the router with the larger IP address is the BSR. The default value is 0. no ip pim bsr-candidate This command is used to disable the router to announce its candidacy as a bootstrap router (BSR). Format Mode no ip pim bsr-candidate {interface [hash-mask length] [bsr-priority]} Global Config ip pim dr-priority Use this command to set the priority value for which a router is elected as the designated router (DR). Default Format Mode 1 ip pim dr-priority Interface Config no ip pim dr-priority Use this command to disable the interface from being the BSR border. Format Mode no ip pim dr-priority Interface Config ip pim join-prune-interval This command is used to configure the interface join/prune interval for the PIM router. The join/prune interval is specified in seconds. This parameter can be configured to a value from 0 to 18000. Default Format Mode 60 ip pim join-prune-interval Interface Config IP Multicast Commands 333