Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 266

ProSafe Managed Switch ip helper enable Use this command to enable relay of UDP packets. This command can be used to temporarily disable IP helper without deleting all IP helper addresses. This command replaces the bootpdhcprelay enable command, but affects not only relay of DHCP packets, but also relay of any other protocols for which an IP helper address has been configured. Default Format Mode disabled ip helper enable Global Config no ip helper enable Use this command to disable relay of all UDP packets. Format Mode no ip helper enable Global Config ip helper-address Use this command to add a unicast helper address to the list of helper addresses on an interface. This is the address of a DHCP server. This command can be applied multiple times on the routing interface to form the helper addresses list until the list reaches the maximum supported helper addresses. Format Mode ip helper-address {|dhcp|domain|isakmp|mobile-ip|nameserver| netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time} Interface Config no ip helper-address Use this command to remove the IP address from the previously configured list. The no command without an argument removes the entire list of helper addresses on that interface. Format Mode no ip helper-address {} {|dhcp|domain|isakmp|mobile-ip|nameserver| netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time} Interface Config Routing Commands 266