Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 186

ProSafe Managed Switch LLDP (802.1AB) Commands This section describes the command you use to configure Link Layer Discovery Protocol (LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802 LAN to advertise major capabilities and physical descriptions. The advertisements allow a network management system (NMS) to access and display this information. lldp transmit Use this command to enable the LLDP advertise capability. Default Format Mode enabled lldp transmit Interface Config no lldp transmit Use this command to return the local data transmission capability to the default. Format Mode no lldp transmit Interface Config lldp receive Use this command to enable the LLDP receive capability. Default Format Mode enabled lldp receive Interface Config no lldp receive Use this command to return the reception of LLDPDUs to the default value. Format Mode no lldp receive Interface Config lldp timers Use this command to set the timing parameters for local data transmission on ports enabled for LLDP. The determines the number of seconds to wait between transmitting local data LLDPDUs. The range is 1-32768 seconds. The is the multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier Switching Commands 186