Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 269

ProSafe Managed Switch enable (OSPF) This command resets the default administrative mode of OSPF in the router (active). Default Format Mode enabled enable Router OSPF Config no enable (OSPF) This command sets the administrative mode of OSPF in the router to inactive. Format Mode no enable Router OSPF Config network area (OSPF) Use this command to enable OSPFv2 on an interface and set its area ID if the IP address of an interface is covered by this network command. Default Format Mode disabled network area Router OSPF Config no network area (OSPF) Use this command to disable the OSPFv2 on a interface if the IP address of an interface was earlier covered by this network command. Format Mode no network area Router OSPF Config ip ospf area Use this command to enable OSPFv2 and set the area ID of an interface. The is an IP address formatted as a 4-digit dotted-decimal number or a decimal value in the range of . This command supersedes the effects of the network area command. It can also be used to configure the advertiseability of the secondary addresses on this interface into the OSPFv2 domain. Default Format Mode disabled ip ospf area [secondaries none] Interface Config Routing Commands 269