Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 586

ProSafe Managed Switch show ip address-conflict This command displays the status information corresponding to the last detected address conflict. Term Definition Address Conflict Detection Status Identifies whether the switch has detected an address conflict on any IP address. Last Conflicting IP Address The IP Address that was last detected as conflicting on any interface. Last Conflicting The MAC Address of the conflicting host that was last detected on any interface. MAC Address Time Since Conflict Detected The time in days, hours, minutes and seconds since the last address conflict was detected. clear ip address-conflict-detect This command clears the detected address conflict status information. Format Mode clear ip address-conflict-detect Privileged EXEC Link Local Protocol Filtering Commands Link Local Protocol Filtering (LLPF) allows the switch to filter out multiple proprietary protocol PDUs, such as Port Aggregation Protocol (PAgP), if the problems occur with proprietary protocols running on standards-based switches. If certain protocol PDUs cause unexpected results, LLPF can be enabled to prevent those protocol PDUs from being processed by the switch. llpf blockall Use this command to block LLPF protocol(s) on a port. Use blockall to filter all PDUs with a DMAC of 01:00:00:0C:CC:CX on the interface. Use blockisdp to filter the ISDP packets on the interface. Use blockvtp to filter the VTP packets on the interface. Use blockdtp to filter the DTP packets on the interface. Use blockudld to filter the UDLD packets on the interface. Use blockpagp to filter the PAGP packets on the interface. Use blocksstp to filter the SSTP packets on the interface. Format Mode Default llpf {blockisdp | blockvtp | blockdtp | blockudld | blockpagp | blocksstp | blockall } Interface Config Disable Utility Commands 586