Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 334

ProSafe Managed Switch no ip pim join-prune-interval Use this command to set the join/prune interval to the default value. Format Mode no ip pim join-prune-interval Interface Config ip pim register-rate-limit This command configures the Register Threshold rate for the Rendezvous Point router to switch to a source-specific shortest path. The valid values are from (0 to 2000 kilobits/sec). Default Format Mode 0 ip pim register-rate-limit Global Config no ip pim register-rate-limit This command resets the register threshold rate for the Rendezvous Pointer router to the default value. Format Mode no ip pim register-rate-limit Global Config ip pim rp-address This command is used to statically configure the RP address for one or more multicast groups. The parameter is the IP address of the RP. The parameter is the group address supported by the RP. The parameter is the group mask for the group address. The optional keyword override indicates that if there is a conflict, the RP configured with this command prevails over the RP learned by BSR. Default Format Mode disabled ip pim rp-address [override] Global Config no ip pim rp-address This command is used to statically remove the RP address for one or more multicast groups. Format Mode no ip pim rp-address [override] Global Config IP Multicast Commands 334