Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 473

ProSafe Managed Switch mac access-group This command either attaches a specific MAC Access Control List (ACL) identified by to an interface, or associates it with a VLAN ID, in a given direction. The parameter must be the name of an existing MAC ACL. An optional sequence number may be specified to indicate the order of this mac access list relative to other mac access lists already assigned to this interface and direction. A lower number indicates higher precedence order. If a sequence number is already in use for this interface and direction, the specified mac access list replaces the currently attached mac access list using that sequence number. If the sequence number is not specified for this command, a sequence number that is one greater than the highest sequence number currently in use for this interface and direction is used. This command specified in 'Interface Config' mode only affects a single interface, whereas the 'Global Config' mode setting is applied to all interfaces. The VLAN keyword is only valid in the 'Global Config' mode. The 'Interface Config' mode command is only available on platforms that support independent per-port class of service queue configuration. Note: The option may or may not be available, depending on the platform. Format Modes mac access-group [vlan ] [in|out] [sequence ] • Global Config • Interface Config no mac access-group This command removes a MAC ACL identified by from the interface in a given direction. Format Modes no mac access-group [vlan ] in • Global Config • Interface Config show mac access-lists This command displays a MAC access list and all of the rules that are defined for the MAC ACL. Use the [name] parameter to identify a specific MAC ACL to display. Format Mode show mac access-lists [name] Privileged EXEC Quality of Service (QoS) Commands 473