Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 488

ProSafe Managed Switch Term Periodic start Periodic end Definition Start time and day for periodic entry. End time and day for periodic entry. Auto-Voice over IP Commands This section describes the commands you use to configure Auto-Voice over IP (VoIP) commands. The Auto-VoIP feature explicitly matches VoIP streams in Ethernet switches and provides them with a better class-of-service than ordinary traffic. When you enable the Auto-VoIP feature on an interface, the interface scans incoming traffic for the following call-control protocols: • Session Initiation Protocol (SIP) • H.323 • Skinny Client Control Protocol (SCCP) When a call-control protocol is detected, the switch assigns the traffic in that session to the highest CoS queue, which is generally used for time-sensitive traffic. auto-voip all Use this command to enable VoIP Profile on the interfaces of the switch. Default Format Mode disabled auto-voip all Global Config no auto-voip all Use this command to disable VoIP Profile on the interfaces of the switch. Format Mode no auto-voip all Global Config auto-voip Use this command to enable VoIP Profile on the interface. Default Format Mode disabled auto-voip Interface Config Quality of Service (QoS) Commands 488