Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 420

ProSafe Managed Switch If you use the summary parameter, the command displays the following column headings in the output table: Term Source IP Group IP Protocol Incoming Interface Outgoing Interface List Definition The IP address of the multicast data source. The IP address of the destination of the multicast packet. The multicast routing protocol by which this entry was created. The interface on which the packet for this source arrives. The list of outgoing interfaces on which this packet is forwarded. IPv6 PIM Commands This section describes the Protocol Independent Multicast (PIM) commands that support the PIM version of IPv6. ipv6 pim dense(Global Config) Use this command to administratively enable PIM-DM Multicast Routing Mode across the router (Global Config). Default Format Mode disabled ipv6 pim dense • Global Config • Interface Config no ipv6 pim dense (Global Config) Use this command to administratively disable PIM-DM Multicast Routing Mode either across the router (Global Config) or on a particular router (Interface Config). Format Mode no ipv6 pim dense Global Config ipv6 pim (Interface Config) Use this command to set the administrative mode of PIM on an interface to enabled. Default Format Mode disabled ipv6 pim Interface Config IPv6 Multicast Commands 420