Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 291

ProSafe Managed Switch Term Definition Stub Router When OSPF runs out of resources to store the entire link state database, or any other state information, OSPF goes into stub router mode. As a stub router, OSPF re-originates its own router LSAs, setting the cost of all non-stub interfaces to infinity. To restore OSPF to normal operation, disable and re-enable OSPF. Exit Overflow Interval The number of seconds that, after entering overflow state, a router will attempt to leave overflow state. External LSDB Overflow When the number of non-default external LSAs exceeds the configured limit, External LSDB Limit, OSPF goes into LSDB overflow state. In this state, OSPF withdraws all of its self-originated non-default external LSAs. After the Exit Overflow Interval, OSPF leaves the overflow state, if the number of external LSAs has been reduced. External LSA Count The number of external (LS type 5) link-state advertisements in the link-state database. External LSA Checksum The sum of the LS checksums of external link-state advertisements contained in the link-state database. AS_OPAQUE LSA Count Shows the number of AS Opaque LSAs in the link-state database. AS_OPAQUE LSA Checksum Shows the sum of the LS Checksums of AS Opaque LSAs contained in the link-state database. New LSAs Originated The number of new link-state advertisements that have been originated. LSAs Received The number of link-state advertisements received determined to be new instantiations. LSA Count The total number of link state advertisements currently in the link state database. Maximum Number of LSAs The maximum number of LSAs that OSPF can store. LSA High Water The maximum size of the link state database since the system started. Mark Retransmit List The total number of LSAs waiting to be acknowledged by all neighbors. An LSA may be Entries pending acknowledgment from more than one neighbor. Maximum Number of Retransmit Entries The maximum number of LSAs that can be waiting for acknowledgment at any given time. Retransmit Entries High Water Mark The highest number of LSAs that have been waiting for acknowledgment. External LSDB The maximum number of non-default AS-external-LSAs entries that can be stored in the Limit link-state database. Default Metric Default value for redistributed routes. Default Passive Setting Shows whether the interfaces are passive by default. Default Route Advertise Indicates whether the default routes received from other source protocols are advertised or not. Routing Commands 291