Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 495

ProSafe Managed Switch used to reset the PoE port. The command can also reset the power-delivering ports. Note that this command takes effect only once after it is executed and cannot be saved across power cycles. Format Mode poe reset Global Config Interface Config poe reset auto Use this command to set the auto-reset mode. When auto-reset mode is enabled, the PoE port will be automatically reset if an error, such as overload, is detected on the port. By default the auto reset mode is enabled. This command allows you to set the mode based on each individual PoE unit or all PoE units. Format Mode Default poe reset auto {|all} Global Config Enable no poe reset auto Use this command to clear autoreset mode. Format Mode no poe reset auto {|all} Global Config poe timer schedule name Use this command to allow you to attach a timer schedule to a PoE port. You can define a time schedule using the existing time range commands. This schedule has start and stop times. When this timer schedule is applied to a PoE-enabled port, the capability of the port to deliver power is affected. At the scheduled start time, the PoE port is disabled such that it cannot deliver any power. At the scheduled stop time, the PoE port is reenabled so that it can deliver power. Note: For information about creating a timer schedule, see Time Range Commands for Time-Based ACLs on page 485. Format Mode poe timer schedule Interface Config Power over Ethernet (PoE) Commands 495