Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 118

ProSafe Managed Switch Term Ucast Mode Ucast Level Definition Shows whether the Unknown Unicast or DLF (Destination Lookup Failure) storm control mode is enabled or disabled. The Unknown Unicast or DLF (Destination Lookup Failure) storm control level. Port-Channel/LAG (802.3ad) Commands This section describes the commands you use to configure port-channels, which are also known as link aggregation groups (LAGs). Link aggregation allows you to combine multiple full-duplex Ethernet links into a single logical link. Network devices treat the aggregation as if it were a single link, which increases fault tolerance and provides load sharing. The LAG feature initially load shares traffic based upon the source and destination MAC address.Assign the port-channel (LAG) VLAN membership after you create a port-channel. If you do not assign VLAN membership, the port-channel might become a member of the management VLAN which can result in learning and switching issues. A port-channel (LAG) interface can be either static or dynamic, but not both. All members of a port channel must participate in the same protocols.) A static port-channel interface does not require a partner system to be able to aggregate its member ports. Note: If you configure the maximum number of dynamic port-channels (LAGs) that your platform supports, additional port-channels that you configure are automatically static. addport This command adds one port to the port-channel (LAG). The interface is a logical unit/slot/port number or a group ID of a configured port-channel. Note: Before adding a port to a port-channel, set the physical mode of the port. For more information, see speed on page 41. Format Mode addport {|lag } Interface Config Switching Commands 118