Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 377

ProSafe Managed Switch ipv6 ospf cost This command configures the cost on an OSPF interface. The parameter has a range of 1 to 65535. Default Format Mode 10 ipv6 ospf cost Interface Config no ipv6 ospf cost This command configures the default cost on an OSPF interface. Format Mode no ipv6 ospf cost Interface Config ipv6 ospf dead-interval This command sets the OSPF dead interval for the specified interface. The value for is a valid positive integer, which represents the length of time in seconds that a router's Hello packets have not been seen before its neighbor routers declare that the router is down. The value for the length of time must be the same for all routers attached to a common network. This value should be some multiple of the Hello Interval (i.e., 4). Valid values range for is from 1 to 2147483647. Default Format Mode 40 ipv6 ospf dead-interval Interface Config no ipv6 ospf dead-interval This command sets the default OSPF dead interval for the specified interface. Format Mode no ipv6 ospf dead-interval Interface Config ipv6 ospf hello-interval This command sets the OSPF hello interval for the specified interface. The value for is a valid positive integer, which represents the length of time in seconds. The value for the length of time must be the same for all routers attached to a network. Valid values for range from 1 to 65535. Default 10 IPv6 Commands 377