Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 485

ProSafe Managed Switch Term Definition IP DSCP The value specified for IP DSCP. Flow Label The value specified for IPv6 Flow Label. Log Displays when you enable logging for the rule. Assign Queue The queue identifier to which packets matching this rule are assigned. Mirror Interface The unit/slot/port to which packets matching this rule are copied. Redirect Interface The unit/slot/port to which packets matching this rule are forwarded. Time Range Name Displays the name of the time-range if the IPv6 ACL rule has referenced a time range. Rule Status Status(Active/Inactive) of the IPv6 ACL rule. Time Range Commands for Time-Based ACLs Time-based ACLs allow one or more rules within an ACL to be based on time. Each ACL rule within an ACL, except for the implicit deny all rule, can be configured to be active and operational only during a specific time period. The time range commands allow you to define specific times of the day and week to implement time-based ACLs. The time range is identified by a name and can then be referenced by an ACL rule defined with in an ACL. time-range Use this command to create a time range identified by name, consisting of one absolute time entry and/or one or more periodic time entries. The name parameter is a case-sensitive, alphanumeric string from 1 to 31 characters that uniquely identifies the time range. An alpha-numeric string is defined as consisting of only alphabetic, numeric, dash, underscore, or space characters. If a time range by this name already exists, this command enters Time-Range config mode to allow updating the time range entries Note: When you successfully execute this command, the CLI mode changes to Time-Range Config mode. Format Mode time-range Global Config Quality of Service (QoS) Commands 485